|
Temperature detector of a cooling fluid 40 Look chapter 3 of section 7 the Temperature detector of air arriving in the engine 41 On early engines the gauge температуры arriving in the engine воздуха it is located on an underside of throttle knot. On later engines the gauge is неотъемлемой a pressure control device part in впускном a collector. 42 unhook a wire from отрицательной plugs of the accumulator battery. 43 unhook an electric socket and turn out the gauge from a collector. 44 installation is spent in последовательности, return to removal. The gauge of position of a bent shaft 45 Gauge of position of a bent shaft is located on a front face картера clutches and is actually inaccessible. 46 unhook a wire from отрицательной plugs of the accumulator battery. 47 for access to the gauge release clamps of fastening of wires and a cooling hose. 48 Unhook from the gauge электрический a socket. 49 Oslabte a bolt of fastening of the gauge (it is not required to turn out completely a bolt) and, rotating the gauge case, отсоедините it from a bolt (fig. 8.32). Поднимая upwards, remove the gauge from the engine 50 Installation it is spent in последовательности, return to removal, thus establish into place and fix провода and a cooling hose the Gauge of a detonation 51 Look section 12. The Speed sensor of the car 52 Speed sensor of the car be a drive gear integral part спидометра. Look section 15 Engines of 1,8 l
7 Rigid air vents in rear части the engine, uniters турбокомпрессор with a flexible inlet air vent and an intake manifold, are inaccessible on the engine established in the car. For access to air vents необходимо to remove the engine/transmission as it is described in section 6 or to remove a front suspension subframe as it is described in section 18. 8 After access reception begin removal of a rigid air vent турбокомпрессора for what unhook a hose of ventilation of a crankcase from the top part воздуховода (fig. 9.5). 9 Turn out a bolt, крепящий воздуховод to an intake manifold elbow the Gauge of position of a cam shaft 11 Gauge of position распределительного a shaft is established on the right side in a cover of a head of cylinders, behind a cam shaft pulley. 12 remove the top and intermediate housings of a toothed belt as it is described in section 4. 13 Unhook from the gauge of position of a cam shaft an electric socket (fig. 9.42). 14 Turn out a bolt and remove the gauge of position of a cam shaft from a cover of a head of cylinders. 15 establish the position gauge распределительного a shaft and adjust its position for what do not tighten a bolt of fastening of the gauge. 16 air spacing between a tip of the gauge and a slot-hole plate in the rear |